10/10/2016

Reflash Carprog MCU ARM by Jtag programmer

Here is the tutorial on re-flashing carprog clone Mcu AT91SAM7S256 step by step.

Tool use: Carprog v8.21 firmware

We need the stuff:
1- AT91SAM7S256.bin
2- Jtag programmer
3- Jtag software

We need to prepare the Carprog to connect to Jtag programmer but first the flash need to be erased, the Jtag function in mcu is disabled, you can't connect to the mcu before erase the flash. Remove the AT88SC eeprom from the board, please note where is the pin 1 in eeprom before remove:

AT88SC

Carefully lift the pin 55 (reset) of the mcu and solder a wire and secure it with a small ammount of silicone (you don't want to broke the pin in the process).
Connect the Carprog (with the pin 55 dissconected) to the 12v supply, wait about 10 seconds and connect the wire from pin 55 to Vcc (3.3V) in Carprog:
Carprog-1

Carprog 2
Wait from 5 to 10 seconds after connect the 12v supply, the flash content will be erased and the Jtag option of the Mcu will be enabled now. If not work leave connected for about 3 to 5 minutes. Disconnect the 12v supply from CarProg full  and remove the pin 55 wire from vcc. The pin 55 must remain disconnected until the programming process is done.



Ok, that’s it. I make it; and you try on you risk.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.