FgTech Galletto V54 read and write ST10Fxx via Tricore Boot Mode

FgTech Galletto v54 master is properly the most user-friendly ECU tuning kit comparing with other clone master version (like KESS or MPPS). My two sets of FgTech galletto ECU programmers (one main unit and another with additional BDM Frame) were delivered from obdii365.com for less than 45 bucks.

Galletto Software was not difficult to install within 3 minutes.

Here I successfully read and write SF10Fxx (K-Line) via Tircore Boot Mode. The FgTech v54 ECU tuning box would prompt which way you are going to read and write the ECU (via OBD, BDM or Tircore boot mode).

After well install and connect FgTech galletto ecu programmer, come to software main program, select vehicle and engine type

Select “Read” and then “Write”, well, it is quite easy

I have tested some other models:

EDC16U1 (VAG) Read/Write ok (OBD)

EDC15V (VAG) Read/Write ok (OBD)

Audi A6 (TRICORE BOOT)

E70 3.0D EDC16 (BDM)

Renault Delphi 2007 k-line

Still leaning on it and will list all tested work ECUs by mini Galletto master.