Read Iveco EDC7UC31 by FGTech Galletto and Ktag

Here are two optional solutions of how to read Iveco EDC7UC31 Bosch ECU by using FGTech galletto and Ktag ksuite v2.10 respectively.

This is the Iveco truck ECU Bosch EDC7UC31 to read:

Solution 1: Ktag v2.10 read EDC7UC31 Bosch ECU

Tested with Ktag master ecu tuning kit firmware v5.001 and ksuite v2.10 software from obdii365.com

Here goes to the ecu reading process…

Select truck-> Iveco truck-> Cursor B-> Bosch EDC7UC31 to read the ecu data

Note: there are lots of Ktag clones with different firmware & software versions. Some are designed for cars, some for trucks. But sometimes even the truck version fails to do on trucks. So the real fact only can be learned by testing yourself, with luck.

Solution 2: FGTech 2 & special adapter read Iveco EDC7UC31 without issues

The FgTech galletto 2 master ecu programmer is offered by obdii365.com also.

The process of EDC7UC31 ecu reading…

Note: EDC7UC31 ecu reading through galletto needs luck. Some people in forums said they failed to this. Even the experienced

– So which ecu programmer you should choose to read EDC7UC31 ecu?

–  It depends. Both can read EDC7UC31 successfully, with disassembling the ecu. Here list some aspects for you to think about your purchase.

Price:

K-tag v2.10: $79.00 

Fgtech 2: $29.99

Reading speed:

Ktag: about 5 minutes to complete the ecu reading

Fg tech: about 3 minutes for it

–> Conclusion:

They both work good, but KTAG runs without tokens limitation, perfect with checksum, compared with FGTech.

Good luck when reading EDC7UC31 ecu.

http://blog.obdii365.com/2016/11/27/read-iveco-edc7uc31-ok-with-fgtech-ktag/