Read Bosch EDC15P+ Boot with MPPS, Fgtech or Kess V2?

Question before entering:

I have some trouble with my spare EDC15P+ ECUs.  I have now invested in a MPPS V21 because of its booting capabilities!  But No matter what i do, MPPS keeps saying “Booting of ECU failed” or it freezes during connection establishment. I have tried this om 3 different ECU’s with bad flash and 2 PC’s.

The procedure i use:
Generic -> Micro Boot -> EDC15P -> Pin 24 to ground and Power On -> Remove ground from Pin 24 -> Select ECU ID

Happens every time and it’s driving me nuts. I have bought MPPS for the sole purpose of recovering bad ECU’s, so i really hope that some of you maybe can help me with this.

Expert solutions:

Solution 1: with MPPS

With MPPS V21, you need luck. V21 maybe too new to this ecu. 

Check with multimeter pin140 to pin44 and pin104 to pin24.

I bought MPPS HW12 china clone, software v16 for hardware 12. For a long time ago I had a similar problem with VW Sharan , I do not remember exactly how I was reinstall the firmware on it.  But finally it works. Here are some pictures:

Solution 2:

MPPS V13 no problem on this ecu

I try read with kess v2 and mpps v21 edc15p+ and I get error, but with mpps v13 no problem to reading this ecu on table.

So i finally got my spare ECU’s working again. I ordered a MPPS v13 ecu flasher, and that one was able to bootflash all the ECU’s.

Solution 3:

Kess v2 master read EDC15P+ on bench on issues

Testing edc15p+ of a Seat Ibiza

Solution 4: 

Fgtech Galletto V54 on bench Writing vw EDC 15 P+ no problem

VW pasat 1.9 PD writing edc 15p+ 115 mph up to 130mph and egr off.

http://blog.obdii365.com/2018/05/11/read-vag-bosch-edc15p-boot-with-mpps-fgtech-or-kess-v2/